PO 400 – Instrumentation Engineers

8500 -10500 kW Output

The PO Series burner can operate oil (Class D light oil, Class G HFO) and available in standard outputs from 3.3MW to 18MW. The PO Series burner is commonly used on large industrial steam and hot water boilers.

Information

Key Features:

Available in monoblock design up to P310 or a duoblock design with a floor mounted combustion air fan
Low NOx Head
Electronic micro modulation air fuel ratio control with individual valve servo motors as standard
Variable Speed Drive (VSD) combustion air fan motor
Air inlet silencer (< 85dBA)
Oxygen trim for improved efficiency and reduced emissions
Separate or integrated water level controls for steam boilers
Data Transfer Interface for BMS control

All P series burners are design and manufactured in accordance with EN267 and EN676.

Technical Data

ModelPO		400/9.5	400/9.9	400/10.3	400/10.6	400/11.0	400/11.4	400/11.7
Output (nett CV)	MW	8.5	8.9	9.3	9.6	9.9	10.3	10.5
Fan Size	kW	18.5	22	22	22	22	22	22
Pump Motor (Distillate Fuel)	kW	4.0	4.0	4.0	5.5	5.5	5.5	5.5
Pump Motor (Residual Fuel)	kW	4.0	4.0	4.0	4.0	4.0	4.0	4.0
Pre-heater (Residual Fuel only)	kW	48	48	48	48	48	48	48
Electrical Supply	V/Hz	400/50	400/50	400/50	400/50	400/50	400/50	400/50
Oil inlet pressure	psi	5 to 10	5 to 10	5 to 10	5 to 10	5 to 10	5 to 10	5 to 10
Fuel pump		T5	T5	T5	T5	T5	T5	T5
Operation		Fully Modulating	Fully Modulating	Fully Modulating	Fully Modulating	Fully Modulating	Fully Modulating	Fully Modulating
Control Unit		Autoflame Mini Mk7	Autoflame Mini Mk7	Autoflame Mini Mk7	Autoflame Mini Mk7	Autoflame Mini Mk7	Autoflame Mini Mk7	Autoflame Mini Mk7
Turndown		up to 4:1	up to 4:1	up to 4:1	up to 4:1	up to 4:1	up to 4:1	up to 4:1
Flame Monitor		UV Sensor	UV Sensor	UV Sensor	UV Sensor	UV Sensor	UV Sensor	UV Sensor
Flame tube lengths	mm	430/610	430/610	430/610	430/610	430/610	430/610	430/610
Noise	dBA	96	96	96	96	96	96	96
NOx	mg/kWh	200-280	200-280	200-280	200-280	200-280	200-280	200-280
CO	mg/kWh	<110	<110	<110	<110	<110	<110	<110